topic Re: How to re-establish connection between Robot 2014 and ASD 2014 in Robot Structural Analysis Forum

How to re-establish connection between Robot 2014 and ASD 2014

aliyuaziz — Mon, 08 Jun 2015 16:09:40 GMT

Hello,

My connection between Robot and ASD suddently stop working. I am being asked to Select Data Source that describes the driver I wish to connect to! I tried to unRegServer and RegServer again to no avail. Kindly help.

Best regards,

Aziz

Re: How to re-establish connection between Robot 2014 and ASD 2014

Anonymous — Mon, 08 Jun 2015 16:29:10 GMT

I have the same problem here

Re: How to re-establish connection between Robot 2014 and ASD 2014

Artur.Kosakowski — Tue, 09 Jun 2015 11:10:45 GMT

Do (both of) you have only ASD2014 and RSA 2014 installed or there are newer versions of ASD, RSA, REX or Revit as well?

Re: How to re-establish connection between Robot 2014 and ASD 2014

aliyuaziz — Tue, 09 Jun 2015 19:01:52 GMT

Dear Artur,

Many thanks for your response. I recently installed BIMware REX Piles 2014 onto the Robot 2014. There is no any other Robot on the system.

Best regards,

Aziz

Re: How to re-establish connection between Robot 2014 and ASD 2014

Artur.Kosakowski — Wed, 10 Jun 2015 08:06:09 GMT

Try to register syspaths.dll

Find syspaths.dll (it should be in C:\Program Files\Common Files\Autodesk Shared\Structural\COM\2014)
In CMD unregister by regsvr32 syspaths.dll /u
Register by regsvr32 syspaths.dll

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

Re: How to re-establish connection between Robot 2014 and ASD 2014

Anonymous — Wed, 10 Jun 2015 09:20:05 GMT

This message shows up when regestering or unregestering

Re: How to re-establish connection between Robot 2014 and ASD 2014

Artur.Kosakowski — Wed, 10 Jun 2015 10:10:55 GMT

Have you started cmd.exe as admin (available under RMB)?

Re: How to re-establish connection between Robot 2014 and ASD 2014

Anonymous — Wed, 10 Jun 2015 12:19:35 GMT

Thx alot Mr Kosakowki
it works really fine now