https://forums.autodesk.com/t5/robot-structural-analysis-forum/reactions-table-and-reactions-diagrams/m-p/6988699#M46862 <P>when i display Fy for the linear support supporting the wall, it gives a value that is different than when viewing Fy in the reactions table, what does the first one describe, which one is actual and right?</P><P>&nbsp;</P><P>&nbsp;</P> Sat, 01 Apr 2017 02:40:27 GMT Anonymous 2017-04-01T02:40:27Z https://forums.autodesk.com/t5/robot-structural-analysis-forum/reactions-table-and-reactions-diagrams/m-p/6988699#M46862 <P>when i display Fy for the linear support supporting the wall, it gives a value that is different than when viewing Fy in the reactions table, what does the first one describe, which one is actual and right?</P><P>&nbsp;</P><P>&nbsp;</P> Sat, 01 Apr 2017 02:40:27 GMT https://forums.autodesk.com/t5/robot-structural-analysis-forum/reactions-table-and-reactions-diagrams/m-p/6988699#M46862 Anonymous 2017-04-01T02:40:27Z https://forums.autodesk.com/t5/robot-structural-analysis-forum/reactions-table-and-reactions-diagrams/m-p/6989115#M46863 <P>1st picture&nbsp; shows the reaction per unit of length you chose .Max value 55.25 kN/m and min -124.99 kN/m . If you mark average or integral value ,it will show the correspondent value for the whole linear support.</P> <P>&nbsp;</P> <P>The table shows the reaction values for each node . The "sum of reactions" for these same nodes should agree with the integral value of the graphic result</P> Sat, 01 Apr 2017 14:41:30 GMT https://forums.autodesk.com/t5/robot-structural-analysis-forum/reactions-table-and-reactions-diagrams/m-p/6989115#M46863 Rafacascudo 2017-04-01T14:41:30Z