topic Re: I'm trying steel moment connection design - working forces or factored one? in Robot Structural Analysis Forum

I'm trying steel moment connection design - working forces or factored one?

Anonymous — Wed, 09 May 2018 13:54:34 GMT

Can someone tell steel moment connection design procedure in Robot. I'm trying steel moment connection design in Robot first time never done this before. Does it need to provide working forces or factored one?

@Anonymous Artur Kosakowski edited the topic from 'Steel Moment Connection design - beam connecting to column web' for better findability and marked post as the solution. If it did not work as an answer, please post your reply in this thread so that I can unmark the solution.

Re: I'm trying steel moment connection design - working forces or factored one?

Artur.Kosakowski — Wed, 09 May 2018 13:55:01 GMT

Hi @Anonymous

The later. assuming that you design according to Eurocode you need to use the ULS (with load factors) combination type.

If I managed to answer your question(s) press the Accept as Solution button please. This will help other users to find solution(s) much faster. Thank you.

Re: I'm trying steel moment connection design - working forces or factored one?

Anonymous — Thu, 10 May 2018 03:39:57 GMT

What about with India codes?

Also for connection design is there is any option to see forces given for connection design are correctly applied or not as the calculation report generated do not show this. Is there is any option to see free body diagrams which shows force distribution and directions etc

Re: I'm trying steel moment connection design - working forces or factored one?

Artur.Kosakowski — Thu, 10 May 2018 08:02:32 GMT

Hi @Anonymous

The Indian codes is not supported in the steel connection module. Could you attach a sample of the report as you would like to see it?

Re: I'm trying steel moment connection design - working forces or factored one?

Anonymous — Thu, 10 May 2018 08:41:07 GMT

pls see attached

Re: I'm trying steel moment connection design - working forces or factored one?

Artur.Kosakowski — Thu, 10 May 2018 10:39:52 GMT

Hi @Anonymous

After calculating the connection press the indicated button. Then you can add this dialog to the report as the screen capture if required.

If one or more of these posts answered your question, please click Accept as Solution on the posts that helped you so others in the community can find them easily.