topic Re: Two way cladding does not consider opening in Robot Structural Analysis Forum

Two way cladding does not consider opening

nali_ameen — Wed, 01 May 2024 10:22:59 GMT

Hi,

I am trying to distribute loads from a cladding (with two opening) to beams. the 1st opening behaves as expected as it skips load distribution in the opening area. But, the 2nd opening is not working as expected as shown in the load distribution regions below.

Attached is my model.

Thank you

Re: Two way cladding does not consider opening

Rafacascudo — Wed, 01 May 2024 13:25:13 GMT

I see 2 options .

1- redo de opening contour avoiding touching the cladding edges as I did in the picture or

2- redo the cladding contour including the openning "rectangle" into it and also creating a small triangle cladding in the botton left

Re: Two way cladding does not consider opening

nali_ameen — Wed, 01 May 2024 13:48:48 GMT

Thank you Rafael, I tried the 1st option and worked.

Re: Two way cladding does not consider opening

Simau — Wed, 01 May 2024 16:44:59 GMT

@nali_ameen

Did you check BM after correcting roof claddings as suggested by @Rafacascudo

Re: Two way cladding does not consider opening

nali_ameen — Wed, 01 May 2024 18:16:09 GMT

yes, I have checked the BM and it wasn't correct. But, offsetting the opening little bit from the edge has solved the load distribution issue.