topic Re: Slab provided reinforcement ar at 0 calculation note in Robot Structural Analysis Forum

Slab provided reinforcement ar at 0 calculation note

Anonymous — Tue, 29 Jan 2019 16:18:55 GMT

Hey Forum

I have made a simple model, and are on the edge of ripping my hair out.

My problem:

In my calculation note for the plate i get this text, making it not print the provided reinforcement in blue text as my other output has been. (as seen in pic 1).

I have limited RSA options of reinforcement choice to ø20 and ø25, i have given a max and min spacing, and only to use bars. I get no warnings and i can see in my plot that I'm vell above the req. reinforcement needed. It also runs the verification perfectly without warning and get moment and derformation plot that looks correct. except the calc. note.

Can anyone help me?

On a side note, i have an identical plate with a huge hole in the middle, which runs without a problem.

Running RSA 2018, Win 10.

Thanks in advange

Re: Slab provided reinforcement ar at 0 calculation note

Anonymous — Tue, 29 Jan 2019 16:21:27 GMT

model attached

Re: Slab provided reinforcement ar at 0 calculation note

Artur.Kosakowski — Wed, 30 Jan 2019 16:58:01 GMT

Hi @Anonymous

I can't see any issue. Could you check the attached file?

If I managed to answer your question(s) press the Accept as Solution button please. This will help other users to find solution(s) much faster. Thank you.

Re: Slab provided reinforcement ar at 0 calculation note

Anonymous — Thu, 31 Jan 2019 13:35:31 GMT

Hi Artur

You are right that when i load the file, without changing anything I do not get a warning.

However, do i choose "list of possible solutions" anyone except the one picked, I get the warning again.

Best

Kim

Re: Slab provided reinforcement ar at 0 calculation note

Artur.Kosakowski — Tue, 12 Feb 2019 13:14:15 GMT

Hi @Anonymous

I don't see that either

If I managed to answer your question(s) press the Accept as Solution button please. This will help other users to find solution(s) much faster. Thank you.

Re: Slab provided reinforcement ar at 0 calculation note

Anonymous — Wed, 13 Feb 2019 07:19:14 GMT

Hey Arthur

I managed to fix it anyway.

I choose only ø20 and ø25, by adding bar ø8, ø10, and ø12 it somehow managed not to show the red text in the calcnote after i run the verification.

It did not add any reinforcement or used it, but somehow i could extract results without any red text in it.

So i guess the problem resolved it self.