Can´t create a profile sweep

Ajtb — Thu, 19 Oct 2023 15:08:29 GMT

I´ll attach the path and the profile below to see if anyone has the same issue or its my profile lines. I tried the following.

New model.

Attach dwg for path to get the middle path of my bridge.

Create a spline out the path.

Model in place > create sweep and then create a profile with the same profile i provided in dwg, but made in Revit.

And still is showing errors, i tried doing it without the 4 lightenings, with a full box, and it´s just not working. Then i thought it was because of my spline, but is not working with a normal line model either.

I tried to look up the error ID, but it doesnt give me any hint or where the mistake might be.

Any insight?

Re: Can´t create a profile sweep

jay_colc — Thu, 19 Oct 2023 16:12:13 GMT

I created the Sweep Path by Pick Line and Tabbed to select the dwg center line and had an issue with profile when i included the holes/circles, ignoring them it worked okay so needed to use pick line including the centre vertical small elements

topic Re: Can´t create a profile sweep in Revit Structure Forum

Can´t create a profile sweep

Re: Can´t create a profile sweep