topic Re: Adaptative Girder in Revit Structure Forum

Adaptative Girder

JEdu_GM — Fri, 17 May 2024 15:03:13 GMT

Hi!

I just created an adaptative (from adaptative families) girder in Revit:

But when I try to place in proyect using the "Repeat" feature, some of them flip over:

Any clue on how this might be fixed?

Thanks in advance!

Re: Adaptative Girder

Tom_Kunsman — Fri, 17 May 2024 16:12:43 GMT

Can you post the family and perhaps the project that you were trying to use repeater on?

Re: Adaptative Girder

JEdu_GM — Fri, 17 May 2024 16:25:00 GMT

Sure!

Both of them, the project was enough, but just in case.

In this one is fixed* (Just exploded the repeat and flip them one by one), but if you delete de girder and try to recreate the repeat, the problem will happend again.

Thanks in advance.

Re: Adaptative Girder

Tom_Kunsman — Fri, 17 May 2024 16:29:28 GMT

In the family make sure the "Always Vertical" is selected. This should fix it.

Re: Adaptative Girder

JEdu_GM — Tue, 11 Jun 2024 16:50:35 GMT

Sorry for the late response,

Tried to create another exercise, and the problem remains:

Some of the placed sections (6 adaptative points) are upside down, in half of the tunnel pieces face one direction, and the other half the totally opposite.

Tried to modified the "Always vertical" value:

And this is what happends,

Is fixed if the flip value is inverted for each of them:

So it has to be something that is not correclty considered in the family itself. I'll attach it just in case anyone could have a look at it.

Thanks in advance.

Re: Adaptative Girder

tkunsmanWKCCM — Tue, 11 Jun 2024 17:49:46 GMT

Can you post the surface too? Trying to recreate this

Re: Adaptative Girder

JEdu_GM — Wed, 12 Jun 2024 21:21:42 GMT

Hi,

The surface is completly done, sadly, using a Dynamo Script.