https://forums.autodesk.com/t5/revit-structure-forum/tapered-pin/m-p/10594008#M13563 <P>Silly question here and I know I can just use linework, but I don't like to when possible.</P><P>I am trying to show a pin going through a couple of L channels. Basically holding two sections together. (only show one section in the screenshot here but you get the picture). I have tried a shear pin, but they only go "up" from the face I show them at. I started from the bottom face and went up, but then it doesn't protrude through like I want and the head also disappears. Is there a pin that I can use in this situation? Kind of like a bolt I suppose but no threads and no nut on the end.</P> Thu, 02 Sep 2021 15:30:02 GMT spakkala 2021-09-02T15:30:02Z https://forums.autodesk.com/t5/revit-structure-forum/tapered-pin/m-p/10594008#M13563 <P>Silly question here and I know I can just use linework, but I don't like to when possible.</P><P>I am trying to show a pin going through a couple of L channels. Basically holding two sections together. (only show one section in the screenshot here but you get the picture). I have tried a shear pin, but they only go "up" from the face I show them at. I started from the bottom face and went up, but then it doesn't protrude through like I want and the head also disappears. Is there a pin that I can use in this situation? Kind of like a bolt I suppose but no threads and no nut on the end.</P> Thu, 02 Sep 2021 15:30:02 GMT https://forums.autodesk.com/t5/revit-structure-forum/tapered-pin/m-p/10594008#M13563 spakkala 2021-09-02T15:30:02Z