https://forums.autodesk.com/t5/revit-mep-forum/npt-threads/m-p/6309935#M70190 <P>I'm new to Revit, and I'm wondering if there is a way to show threads on conduit like you can with bolts and screws in Inventor.</P> Thu, 05 May 2016 13:00:35 GMT Anonymous 2016-05-05T13:00:35Z https://forums.autodesk.com/t5/revit-mep-forum/npt-threads/m-p/6309935#M70190 <P>I'm new to Revit, and I'm wondering if there is a way to show threads on conduit like you can with bolts and screws in Inventor.</P> Thu, 05 May 2016 13:00:35 GMT https://forums.autodesk.com/t5/revit-mep-forum/npt-threads/m-p/6309935#M70190 Anonymous 2016-05-05T13:00:35Z https://forums.autodesk.com/t5/revit-mep-forum/npt-threads/m-p/6309961#M70191 <P>No. Because in general this would be too detailed for Revit.</P> <P>Revit is used for designing buildings. If you would design everything up to the bolt/thread level would create huge unworkable projects. Normally you roughly shape your objects. Look at the differrent typical families inside the libaries to get an idea of detail.</P> <P>You will use detail drawings/documentation to further clarify the items or use other software (like inventor) to get it up to poduction level.</P> <P>If you start designing all the minute details you will&nbsp;run into problems. If you try to draw lines smaller than 0.8 mm Revit will complain that lines are too small.</P> Thu, 05 May 2016 13:12:40 GMT https://forums.autodesk.com/t5/revit-mep-forum/npt-threads/m-p/6309961#M70191 L.Maas 2016-05-05T13:12:40Z