topic Re: view range issue in Revit MEP Forum

view range issue

Anonymous — Mon, 26 Mar 2018 09:01:29 GMT

above level not visible, beams are inside view rage top and cut level.

Re: view range issue

jeroen_vanmassenhove — Mon, 26 Mar 2018 09:07:51 GMT

As the beams are located above your cut plane, you will not see them since you're looking down from the cut plane to the bottom.

However, you can do 2 things:

Use the reflected ceiling plan, this way you're looking UP instead of DOWN.
Make sure the beams are represented in a plan view, as long as they're inside your top range (which they are, like you stated earlier)
For this, you can check this article: https://knowledge.autodesk.com/support/revit-products/learn-explore/caas/sfdcarticles/sfdcarticles/Representation-of-structural-beams-in-Revit-floor-plan-views.html

Kind regards

Re: view range issue

chris.kershaw — Mon, 26 Mar 2018 09:54:03 GMT

Change your cut plane to 50mm above the bottom of your steel & you should see both

Re: view range issue

Anonymous — Mon, 26 Mar 2018 10:24:52 GMT

i changed and try also but i can't see architecture walls means below cut plan because it above beam bottom.

Re: view range issue

chris.kershaw — Mon, 26 Mar 2018 10:32:03 GMT

Strange that usually shows both steel & walls. as that dose not work then maybe there is something else wrong other than the view range

Re: view range issue

Anonymous — Mon, 26 Mar 2018 11:26:08 GMT

actual i'm doing sheet view so i want cut line wall level and above beams hidden lines because pipes through beams, wall cut pattern i need because it looks more ritualistic , structural & architecture is linked to my model .

Re: view range issue

jeroen_vanmassenhove — Mon, 26 Mar 2018 13:05:35 GMT

Have you tried the solution I gave you, the one that was in the link? Because, of what I understand now from your explanation, that is what you are looking for.

Re: view range issue

Anonymous — Wed, 28 Mar 2018 03:01:44 GMT

thank you very much it was solve my problems .

Re: view range issue

m.voss.alvine — Thu, 29 Mar 2018 14:03:50 GMT

please check "accept solution"