topic Re: Pipe Error Coming from Mechanical Equipment in Revit MEP Forum

Pipe Error Coming from Mechanical Equipment

Anonymous — Sun, 31 May 2020 08:13:05 GMT

Hi all,

I have encountered this error, whereby the pipe coming from the mechanical equipment has some error when I run the interference check. (Photo attached). Not sure why..

Thanks!

Re: Pipe Error Coming from Mechanical Equipment

RobDraw — Sun, 31 May 2020 10:08:07 GMT

"Some kind of error" doesn't tell us anything. If you are saying that the interference is the error then what is it interfering with and why is it an error?

Re: Pipe Error Coming from Mechanical Equipment

Anonymous — Sun, 31 May 2020 10:42:40 GMT

Hi,

I have attached the interference check report. It doesn't have any clashes, but yet Revit p

rompts a warning.

Re: Pipe Error Coming from Mechanical Equipment

RobDraw — Sun, 31 May 2020 10:46:49 GMT

Your issue is unclear as what you are saying doesn't make sense. Please explain exactly what you are doing, step by step.

Re: Pipe Error Coming from Mechanical Equipment

fabiosato — Sun, 31 May 2020 21:24:09 GMT

Hello,

Does this equipment have a clearance volume?

Re: Pipe Error Coming from Mechanical Equipment

hmunsell — Mon, 01 Jun 2020 11:54:03 GMT

where are your connectors? from the picture it looks like you Pipe Connector may on the other side of what ever that disk is. if the pipe has to go thru that disk to get to the connector it may cause an error.

Re: Pipe Error Coming from Mechanical Equipment

RobDraw — Mon, 01 Jun 2020 12:16:01 GMT

@Anonymous wrote:
Hi,

I have attached the interference check report. It doesn't have any clashes, but yet Revit p

rompts a warning.

I didn't look at the image as you said it doesn't have any clashes. It does. Sorry, I misunderstood your bad grammar.

Most likely, it's a clearance area that is turned off in the view.