topic Re: assembly code for Pipes in Revit MEP Forum

assembly code for Pipes

menline — Thu, 27 Jul 2023 09:06:19 GMT

hello All,

I have the problem to fill in the correct assembly codes for piping.
A copper pipe can serve as a water pipe or gas pipe, but both have a different assembly code,
But only in the properties of the pipe you can enter the assembly code, i.e. that of copper pipe.

How do you all solve this problem ?

Regards,

Menno

Betreff: assembly code for Pipes

iainsavage — Thu, 27 Jul 2023 09:47:47 GMT

Most families have an Assembly Code parameter built-in but it is not compulsory to apply a value to it, in fact I've never used it.

Re: assembly code for Pipes

hmunsell — Thu, 27 Jul 2023 11:14:51 GMT

make different Pipe Types for there different uses. Double click on the Pipe Type in the Project Browser to edit the Assembly Code for each Type.

Re: assembly code for Pipes

menline — Thu, 27 Jul 2023 12:02:10 GMT

Yes I thought of that too, but this means a lot of double bend, Tees, etc

Re: assembly code for Pipes

fabiosato — Sat, 29 Jul 2023 02:45:49 GMT

Hello,

You can duplicate the type of the fittings for each assembly code.