topic Re: break line to ramp in REVIT 2016 in Revit Architecture Forum

break line to ramp in REVIT 2016

Anonymous — Mon, 07 Sep 2015 06:45:04 GMT

Does someone know if REVIT 2016 allows for a breakline to ramps same as for stairs? The older versions of REVIT did not.

Thanks

Re: break line to ramp in REVIT 2016

dzanta — Tue, 08 Sep 2015 12:12:38 GMT

breaklines for stairs exists natively in Revit

breaklines for ramps does not exist (must be written into the program)

you can use a 2D detail component (breakline) and try to use it

Re: break line to ramp in REVIT 2016

ennujozlagam — Thu, 17 Sep 2015 07:02:43 GMT

hi, if you want you can try this:

http://autodesk-revit.blogspot.sg/2008/03/ramps-dont-cut.html

Re: break line to ramp in REVIT 2016

Anonymous — Tue, 29 Sep 2015 05:50:56 GMT

thanks,
that is what i ended up doing:)

Re: break line to ramp in REVIT 2016

Anonymous — Thu, 15 Jun 2017 17:32:55 GMT

Hey @dzanta. Thanks !

Re: break line to ramp in REVIT 2016

dzanta — Thu, 15 Jun 2017 17:45:41 GMT

no worries...

Re: break line to ramp in REVIT 2016

ToanDN — Thu, 15 Jun 2017 23:27:14 GMT

@Anonymous

Were you using a masking region to mask the above part of the ramp? What if you have any objects under the ramp such as equipment or floor finish pattern? Would they be masked as well?

Re: break line to ramp in REVIT 2016

Anonymous — Fri, 16 Jun 2017 00:29:41 GMT

Hi,

Yes, I am using masking region.

Unfortunately that hides all that is under the ramp as you say but there is no other way around it.

Re: break line to ramp in REVIT 2016

ToanDN — Fri, 16 Jun 2017 00:42:36 GMT

Of course there are other ways around it. Here's one:

- Override graphic of the ramp and make it 100% Transparent and with dashed outline.

- Draw a masking region to cover the lower part of the ramp so that anything below the upper part are still visible.

Re: break line to ramp in REVIT 2016

GO.math — Tue, 06 Sep 2022 13:04:25 GMT

Hello, i am looking for answers on this poste because i would like to know how in Revit 2023, it is possible to get a cutting line on a concentric ramp.