topic Re: Problem with Wall Sweep in Revit Architecture Forum

Problem with Wall Sweep

Anonymous — Thu, 29 Jun 2017 16:54:50 GMT

Hello,

I would like to know how to solve this problem.

I make the Wall Angle with Wall Sweep, due to the perimeter calculation.
However, at 90 degree junctions according to the posted image, it does not connect as it should. In this case it does not allow the Wall Sweep to be installed at the side of the wall.

Thank you in advance.

Salvar

Re: Problem with Wall Sweep

Anonymous — Thu, 29 Jun 2017 16:53:58 GMT

Hello,

Is it one sweep or two seperate ones ?

can't you modify the sweep ?

If my answer solved your problem , Please Kudo and Accept as solution.

Thanks

Re: Problem with Wall Sweep

Sahay_R — Thu, 29 Jun 2017 17:36:16 GMT

Use the same profile to create a Railing. The Profile will be the Top Rail. Remove the Balusters etc, change the height of the top rail to 0.

The reason for this is that Railings are very forgiving and they can be created in very complicated shapes as well.

Re: Problem with Wall Sweep

ToanDN — Thu, 29 Jun 2017 17:54:33 GMT

Copy and paste that particular corner with walls and wall sweeps to a new file and upload.

Re: Problem with Wall Sweep

chrisplyler — Thu, 29 Jun 2017 19:35:38 GMT

I suspect that you have placed two separate sweep instances.

If you escaped out of the sweep placing mode, and started again, then that is the result. Delete one of them, and replace it by selecting the other and then clicking the "Add segment" tool on the ribbon. In this way you can add back the necessary walls and it will all be one sweep element. Then all the corners will miter correctly.

Re: Problem with Wall Sweep

Anonymous — Tue, 04 Jul 2017 16:37:25 GMT

Hello,

Thank you all for the answers and sorry for the delay in answering them.
However, Wall Sweep has been created in a unique way, but when it reaches the gap it does not allow to create because it is one side of the wall, so I have to create a corner, then it does not join properly

Thank you