topic Re: Revit 2018 inclined floor in Revit Architecture Forum

Revit 2018 inclined floor

Anonymous — Fri, 30 Nov 2018 20:08:50 GMT

How do i make an inclined floor with the thickness of the floor getting smaller through the incline? I would like to have 200 thickness on one side and 180 thickness om the other with and the incline should be -20.

Re: Revit 2018 inclined floor

cbcarch — Fri, 30 Nov 2018 20:22:55 GMT

A few methods:

-Model in-place>Extrusion.

Sketch the profile needed, then create the floor., Grip edit length in Plan view. Set Family Type to Floor.

-Use an in-place Void to cut a floor that is level.

-You could also try to use a Ramp.

-You can use edit sub-elements/points to give the top surface of the floor a slope as needed.

-You can use a slope arrow ( this will "tilt" the whole floor, top and bottom surfaces)

Re: Revit 2018 inclined floor

ToanDN — Fri, 30 Nov 2018 20:23:01 GMT

Create a 200 mm flat floor and edit sub elements to bring the end edge down 20 mm.

Re: Revit 2018 inclined floor

Anonymous — Fri, 30 Nov 2018 20:37:02 GMT

Can't i just change the elevation at the bottom? As in the picture, but how do i change the setting when it is grey?

Re: Revit 2018 inclined floor

ToanDN — Fri, 30 Nov 2018 21:04:13 GMT

@Anonymous wrote:

Can't i just change the elevation at the bottom? As in the picture, but how do i change the setting when it is grey?

See below. And if you read my first post carefully you would notice I said "flat floor".

Re: Revit 2018 inclined floor

barthbradley — Fri, 30 Nov 2018 20:45:32 GMT

How'd I do @Anonymous?

Re: Revit 2018 inclined floor

barthbradley — Fri, 30 Nov 2018 20:55:12 GMT

Re: Revit 2018 inclined floor

Anonymous — Sat, 01 Dec 2018 15:34:18 GMT

Thank you that worked 😄