topic Re: Create floors in Revit API Forum

Create floors

sonicer — Mon, 13 Mar 2017 23:44:02 GMT

Does anyone know where is problem? Is there important ordering of the points? how to check is it closed curve?

or there is other problem?

XYZ profile00 = new XYZ(bod.X + 400 * a1, bod.Y + 400 * b1, 0);
XYZ profile01 = new XYZ(bod.X + 400 * (-a1), bod.Y + 400 * (-b1), 0);

                            other point.....

                            slabCurves.Append(Line.CreateBound(profile00, profile01));
                            slabCurves.Append(Line.CreateBound(profile01, profile11));
                            slabCurves.Append(Line.CreateBound(profile11, profile10));
                            slabCurves.Append(Line.CreateBound(profile10, profile00));

Re: Create floors

jeremytammik — Tue, 14 Mar 2017 07:51:54 GMT

Floor Creation -- http://thebuildingcoder.typepad.com/blog/2011/08/floor-creation.html
Pick Corners and Create Floor -- http://thebuildingcoder.typepad.com/blog/2011/11/pick-corners-and-create-floor.html
Creating a Sloped Floor -- http://thebuildingcoder.typepad.com/blog/2014/03/creating-a-sloped-floor.html

Re: Create floors

Revitalizer — Tue, 14 Mar 2017 07:57:31 GMT

Hi,

the loop is closed if each end point is used by two curves.

Or if your loop consists of a single closed curve, e.g. a circle or ellipse.

Revitalizer

Re: Create floors

sonicer — Tue, 14 Mar 2017 10:23:34 GMT

thx Tammik...I still use your blog.....

But there was problem with Line start point and end point....One line crossed the other one then it is closed curve but not correct. Solved.

Now I have problem the revit lookup show me the length and angle in metric ...milimeters and degree. thats ok

In C# I get this data in radians and the xyz is in inches.? Can I change the input XYZ data to metric?

thx.

Re: Create floors

jeremytammik — Tue, 14 Mar 2017 10:50:23 GMT

http://thebuildingcoder.typepad.com/blog/units/