topic Re: Problem with Wall Edit Profile / Reset Profile when dimension is associated in Revit API Forum

Problem with Wall Edit Profile / Reset Profile when dimension is associated

eddyp — Tue, 08 Oct 2019 21:22:13 GMT

I have a problem with my Revit 2020 after update ~10/6/19. Same files on a different PC ...no problem and behave correctly.

On any file I open I cannot edit or reset "wall" profile of any wall opening that has a dimension associated with it; if no dimension or I delete all dimensions in every view associated with opening then I can delete in edit mode or reset profile. I can move a line to change dimension but cannot delete any part of opening. If I try to delete an opening and select "finish check mark" it will not respond, instead my only option is to use the "X" and exit without saving. Normally an error message would pop up and say that a "dimension reference is invalid", but this is not happening!

Any help ???

Re: Problem with Wall Edit Profile / Reset Profile when dimension is associated

naveen.kumar.t — Wed, 09 Oct 2019 05:15:17 GMT

Hi @eddyp ,

Are you doing anything programmatically?

If not Please note that this discussion forum is dedicated to programming Revit using the Revit API.

Therefore, you cannot expect an answer to a question such as yours relating to installation, product usage or end-user support issues here.

You should try one of the non-API Revit product support discussion forums :

https://forums.autodesk.com/t5/revit-api-forum/this-forum-is-for-revit-api-programming-questions-not-for/td-p/5607765

I hope this helps.

Re: Problem with Wall Edit Profile / Reset Profile when dimension is associated

eddyp — Wed, 09 Oct 2019 14:06:57 GMT

I switched to non - API forum but no help either.

Thanks