topic Weihong 3axis lathe DSP post processor powermill in PowerMill Forum

Weihong 3axis lathe DSP post processor powermill

Anonymous — Thu, 08 Sep 2016 15:49:53 GMT

Facing problem with post processor.. bought a Chinese weihong nk105 g2 DSP controlled lathe. Autodesk engineer says to get me example for NC code and I don't have .

Re: Weihong 3axis lathe DSP post processor powermill

matthew.nichols — Thu, 08 Sep 2016 16:21:02 GMT

Just wanting to make sure...your subject line has powermill mentioned. Are you using Inventor HSM or HSMWOrks?

Is there anyway to contact the manufacturer to get a programming manual or sample code that could run on the machine showing capabilities?

Re: Weihong 3axis lathe DSP post processor powermill

Anonymous — Thu, 08 Sep 2016 16:47:19 GMT

I bought newly power mill 2017 the indian region of Karnataka. The
Autodesk engineer who comes trains us is required example of NC file to
make the post processor. I am just a customer
..

Re: Weihong 3axis lathe DSP post processor powermill

NanchenO — Fri, 09 Sep 2016 08:12:12 GMT

Hi,

If you receivedd any manual with your machine, there should be enough information in it to make a postprocessor.

If not, try the control's manufacturer Internet site.

Olivier

Re: Weihong 3axis lathe DSP post processor powermill

Anonymous — Sat, 10 Sep 2016 07:24:52 GMT

Hi @Anonymous I have noticed you mentioned that you have bought a Lathe.

FeatureCAM is more suitable for lathes than Powermill. Have you seen FeatureCAM?

George

Re: Weihong 3axis lathe DSP post processor powermill

Anonymous — Sat, 10 Sep 2016 09:38:05 GMT

I already buy powermill