topic Re: Postprocessor Question of Four-axis with angle-head in PowerMill Forum

Postprocessor Question of Four-axis with angle-head

henry2cool — Wed, 09 Sep 2020 11:29:45 GMT

Hi ! everyone,I am trying to build a postprocessor for an angle-head which be used to work with a A-axis.
The following GIF show the simulation is ok,but when I try to post a program,I was be stopped by a question:
The NC code is not correct and I can't find out the reason why cause this issue.
Could someone can check my attached files and help me to know the root reason of this situation，Thank you very much!

The simulation seems ok.The NC code postion is not correct.The description of attached files.

Re: Postprocessor Question of Four-axis with angle-head

Meysam_Ghorbani — Wed, 09 Sep 2020 17:03:22 GMT

check this post

Re: Postprocessor Question of Four-axis with angle-head

Anonymous — Wed, 09 Sep 2020 18:31:46 GMT

the nc program is approved ?

Re: Postprocessor Question of Four-axis with angle-head

henry2cool — Thu, 10 Sep 2020 00:40:51 GMT

@Meysam_Ghorbani Thanks for your post, but the output coordinates are the same as mine, which is also incorrect.

Re: Postprocessor Question of Four-axis with angle-head

henry2cool — Thu, 10 Sep 2020 01:00:16 GMT

@Anonymous ，Thanks for your reply, I have checked your NC codes. It works great!

Do you use CLDATA coordinate values to output NC codes?

Based on the above guess, I tried to modify, but it will output an additional Y coordinate value, which is incorrect.
Could you give me some suggestions so that help me complete my post-processing files, thank you much!

Re: Postprocessor Question of Four-axis with angle-head

Anonymous — Thu, 10 Sep 2020 18:35:50 GMT

Hi dear friend. Send me an email. We are not allowed to publish post processor in this forum.

powercam.ir@gmail.com

whats app:+989112235526

Re: Postprocessor Question of Four-axis with angle-head

Meysam_Ghorbani — Thu, 10 Sep 2020 19:46:19 GMT

with the same post processor

good luck.

Re: Postprocessor Question of Four-axis with angle-head

henry2cool — Fri, 11 Sep 2020 05:24:47 GMT

@Anonymous Hi dear friend，Thanks for your help and I have sent an e-mail to you. Looking forward to your reply！

Have a great day！

Re: Postprocessor Question of Four-axis with angle-head

henry2cool — Fri, 11 Sep 2020 05:45:56 GMT

@Meysam_Ghorbani Hi dear friend,I have tried again,but it still doesn't work well.

Thank you for your great help！

Have a great day！

NC program settingPowermill versionPostprocessor verson

Re: Postprocessor Question of Four-axis with angle-head

Anonymous — Fri, 11 Sep 2020 10:22:32 GMT

I showed the correct settings in an image. Adjust according to the image. I also did not receive any email.