https://forums.autodesk.com/t5/powerinspect-forum/is-power-inspect-2020-compatible-with-nikon-cmm-controller/m-p/9508542#M366 <P>I am trying to figure out if Power Inspect 2020 will work with a Nikon NMC300 CMM dcc controller. Does anybody know if this software will work? I downloaded the trial at it does not appear to be but I just want to make sure.</P><P>&nbsp;</P><P>Thank you,</P><P>Jason</P> Tue, 12 May 2020 02:05:34 GMT Anonymous 2020-05-12T02:05:34Z https://forums.autodesk.com/t5/powerinspect-forum/is-power-inspect-2020-compatible-with-nikon-cmm-controller/m-p/9508542#M366 <P>I am trying to figure out if Power Inspect 2020 will work with a Nikon NMC300 CMM dcc controller. Does anybody know if this software will work? I downloaded the trial at it does not appear to be but I just want to make sure.</P><P>&nbsp;</P><P>Thank you,</P><P>Jason</P> Tue, 12 May 2020 02:05:34 GMT https://forums.autodesk.com/t5/powerinspect-forum/is-power-inspect-2020-compatible-with-nikon-cmm-controller/m-p/9508542#M366 Anonymous 2020-05-12T02:05:34Z https://forums.autodesk.com/t5/powerinspect-forum/is-power-inspect-2020-compatible-with-nikon-cmm-controller/m-p/9704412#M367 <P>Hi Jason,</P><P>It's probably too late for you but I'd like to answer so others could find it.</P><P>Well.</P><P>Most of CMM manufacturers provide their machines with embedded I++ server.</P><P>Hence any inspection software could connect to (drive) a CMM via I++ protocol.</P><P>Answer is really simple: Yes, PowerInspect could connect to a Metris CMM via I++ protocol connecting to the Metris I++ Server.</P><P>Hope my answer helps.</P><P>&nbsp;</P><P>Best Regards,</P><P>Alexey</P> Fri, 21 Aug 2020 11:52:53 GMT https://forums.autodesk.com/t5/powerinspect-forum/is-power-inspect-2020-compatible-with-nikon-cmm-controller/m-p/9704412#M367 alexey-zorin 2020-08-21T11:52:53Z