topic Re: Jig and Orthomode in .NET Forum

Jig and Orthomode

Anonymous — Wed, 09 Jan 2008 12:23:19 GMT

I'm jig a leader with an block in the end of the leader. When the orthomode is set to ON the leader not acquire the corret point. What effect have the UserInputControls.GovernedByOrthoMode?
Can anyone help me?
Thanls in advance.

Re: Jig and Orthomode

Anonymous — Wed, 09 Jan 2008 15:15:48 GMT

Are you dragging a rubber-band cursor from a basepoint?

--
http://www.caddzone.com

AcadXTabs: MDI Document Tabs for AutoCAD 2008
Supporting AutoCAD 2000 through 2008
http://www.acadxtabs.com

wrote in message news:5815713@discussion.autodesk.com...
I'm jig a leader with an block in the end of the leader. When the orthomode is set to ON the leader not acquire the corret point. What effect have the UserInputControls.GovernedByOrthoMode?
Can anyone help me?
Thanls in advance.

Re: Jig and Orthomode

Anonymous — Wed, 09 Jan 2008 16:25:02 GMT

Sorry for my bad english.
Yes, the rubber-band is draggig always from the leader last vertice (basepoint) to the current cursor position.

Re: Jig and Orthomode

Anonymous — Thu, 10 Jan 2008 13:26:00 GMT

I solved!
Thanks Tony, for the tips.

Re: Jig and Orthomode

Anonymous — Wed, 23 Jan 2008 16:53:01 GMT

Hanauer, could you post the fix please?

Jeff

Re: Jig and Orthomode

Anonymous — Thu, 24 Jan 2008 10:07:59 GMT

Here is the relevant code:
protected override SamplerStatus Sampler(JigPrompts prompts)
{
JigPromptPointOptions opt = new JigPromptPointOptions();
opt.UserInputControls =
(UserInputControls.Accept3dCoordinates
| UserInputControls.NoNegativeResponseAccepted
| UserInputControls.NullResponseAccepted);
if (m_leader == null)
opt.Message = "\nstart point: ";
else
{
// GovernedByOrthoMode is needed for orthomode
opt.UserInputControls |= UserInputControls.GovernedByOrthoMode;
opt.BasePoint = m_leader.VertexAt(m_leader.NumVertices);
// you can't use opt.UseBasePoint = true
// when ortho is on then not works
if (m_leader.IsSplined)
opt.SetMessageAndKeywords(
"\nSpecify Next point or [Line/Undo]: ",
"Line Undo");
else
opt.SetMessageAndKeywords(
"\nSpecify next point or [Spline/Undo]: ",
"Spline Undo");
}

PromptPointResult res = prompts.AcquirePoint(opt);
}

Re: Jig and Orthomode

Anonymous — Thu, 24 Jan 2008 17:37:21 GMT

Thank you Hanauer