topic Re: Analysis failure problem in Moldflow Insight Forum

Analysis failure problem

Sanjay_paul — Mon, 14 Nov 2016 10:54:30 GMT

When I start the analysis, showing the below dialog box. What's the problem? Here I have attached sdy file of experiment.

mppkumar — Mon, 14 Nov 2016 12:06:44 GMT

Can you share the error message from log file

bernor_mf — Mon, 14 Nov 2016 12:54:58 GMT

Hi Sanjay,

just a control question:

did you install Insight solver as well on the new workstation?

Moldflow Synergy (UI) and Moldflow Insight (solvers) should be installed.

What does Analysis Log say?

If C and empty it means solvers not installed.

Check that the service for job manager is running and not stopped: amijm.exe

Hope this helps.

Regards,

Berndt

statesj — Mon, 14 Nov 2016 14:55:13 GMT

There can sometimes be an issue if the study file names are too long, can you run studies with shorter names without a problem?

Sanjay_paul — Tue, 15 Nov 2016 07:29:21 GMT

Yes the analysis log is totally empty. I am checking now what you mentioned.

Regards

Sanjay Paul