topic Re: Maya 2018.3 HumanIK broken when sent to Motion Builder 2018 in Maya Animation and Rigging Forum

Maya 2018.3 HumanIK broken when sent to Motion Builder 2018

LayLo3D — Wed, 27 Jun 2018 01:47:04 GMT

When I define a HumanIK inside Maya and then send it to MotionBuilder, or FBX export and then open it in MotionBuilder it says my definition is invalid and seems to rotate some of the joints or something. See the screenshots.

If I use MEL commands to define the roll joints manually to 41, 43, 45, 46, 47, and 48 then send it over to MotionBuilder it doesn't say the definition is invalid, but it still does the same weird deformation or joint rotations shown in screenshot 2.

Anyone know what's going on?

Re: Maya 2018.3 HumanIK broken when sent to Motion Builder 2018

sean.heasley — Wed, 27 Jun 2018 16:03:34 GMT

Hi @LayLo3D

Is the deformation you're talking about on the stomach?

That's the only area I'm noticing in your second screenshot that looks a little off compared to the first.

It's also possible this may be related to a known issue with Motion Builder with multiple joints not being allowed to be defined as inline rolls.

Have you tried removing the rig you have in Maya and just exporting the model to Motion Builder and make the rig there? Do the same errors occur?

Re: Maya 2018.3 HumanIK broken when sent to Motion Builder 2018

LayLo3D — Wed, 27 Jun 2018 18:15:12 GMT

Hi @sean.heasley,

Thanks for the reply!

The deformation I'm referring to is at the character's right shoulder and left hip. The figure should be symmetrical.

I have tried creating the rig in MotionBuilder instead and it does seem to work properly, but I use a script in Maya to define the HumanIK skeleton and would like to avoid having to do it manually for each character.

Does MotionBuilder have scripting capabilities?

Re: Maya 2018.3 HumanIK broken when sent to Motion Builder 2018

LayLo3D — Thu, 28 Jun 2018 02:38:07 GMT

Hi @sean.heasley,

I figured out that the deformations are being caused by set driven keys I have set up in Maya. I have set driven keys set up to apply blendshapes when joints are rotated to clean up the joint deformations. Not sure why they're not working properly in MB though, and why some of them are being "turned on" for no reason. Do you have any ideas?

Does MB have something similar to set driven keys? If so, how do I set them up using python?

Thanks in advance!