https://forums.autodesk.com/t5/machining-discussions-forum/2d-contour-multiple-depths/m-p/6080638#M6364 Hello,<BR /><BR />I'm cutting using 2D Contour and multiple depths of cut.<BR />I remove lead in and lead out<BR />Use the ramp lead in only.<BR /><BR />The ramp angle is by default 2 degrees.<BR />I change it 20 degrees<BR /><BR />(for some reason the 20 degrees won't change unless I change the ramp clearance height from the default 0.1 to 0.05, BUT that's besides the point)<BR /><BR />The issue is the first depth of cut uses the specified 20 degrees BUT subsequent depths of cut use a long ramp that seems to be 50% of the chosen contour length (see picture).&nbsp; There is no parameter to modify for subsequent depths of cut.&nbsp; I assume the 20 degree ramp angle should be used for all depths of cut.<BR /><BR />To elaborate, the lead in length on the second depth of cut for a small part with a 4" perimeter would be approximately 2" and a larger part with a 20" perimeter would have a 10" lead in (too much and too slow).<BR /><BR /><BR /> Fri, 12 Jun 2015 12:44:27 GMT Anonymous 2015-06-12T12:44:27Z