https://forums.autodesk.com/t5/machining-discussions-forum/enhancement-request-round-corners/m-p/6094171#M4881 So while I like the option to roll around corners, I would also like to add a radius to them at times, as the roll option can still leave sharp corners. Gibbscam had this feature when I used it and I used it constantly, usually just adding a .005" radius on (obviously external) corners. Perhaps it could be a value box that appears with a checkbox. I like that 2D Contour isn't cluttered right now, so any way to avoid that is good, but I really miss this feature.<BR /><BR />Anyone ever bring this up before? Basically I'm wary of editing the models (they all go in assemblies after all) but would like "functional deburring" if you will. Or does this pose an issue since the simulation will violate the model (although adding chamfers as deburring works...)?<BR /><BR />Edit: wasn't sure if this should be in Support or CAM Discussions, so I put it here. Also, this would be for all packages. Tue, 29 Sep 2015 02:20:30 GMT Steinwerks 2015-09-29T02:20:30Z