https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12315644#M17669 <P>Are you attempting to link the parameter, or just use the value?</P><P>Maybe use "PatternFrameEndQty.Value" if unlinked is fine.</P> Wed, 18 Oct 2023 23:02:28 GMT j-robertson 2023-10-18T23:02:28Z https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12315291#M17668 <P>Is there a way to use a parameter, PatternFrameEndQty in this case, for the circular count when using Patterns.AddCircular?</P><P>&nbsp;</P><PRE><SPAN>Patterns</SPAN>.<SPAN>AddCircular</SPAN>(<SPAN>"Component Pattern - Frame End"</SPAN>, <SPAN>"Frame End (Top)"</SPAN>, <SPAN>PatternFrameEndQty</SPAN>, 180.000000 deg, <SPAN>""</SPAN>, <SPAN>"X Axis"</SPAN>)</PRE><P>&nbsp;</P> Wed, 18 Oct 2023 20:01:01 GMT https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12315291#M17668 brianA32ZM 2023-10-18T20:01:01Z https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12315644#M17669 <P>Are you attempting to link the parameter, or just use the value?</P><P>Maybe use "PatternFrameEndQty.Value" if unlinked is fine.</P> Wed, 18 Oct 2023 23:02:28 GMT https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12315644#M17669 j-robertson 2023-10-18T23:02:28Z https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12316944#M17670 <P>You can use parameter name as you used, but the parameter units must be set to "ul".</P> Thu, 19 Oct 2023 13:28:58 GMT https://forums.autodesk.com/t5/inventor-programming-forum/using-a-paramerter-for-patterns-addcircular-count/m-p/12316944#M17670 Michael.Navara 2023-10-19T13:28:58Z