topic Re: Adding Frame Generator Members in Inventor Forum

Adding Frame Generator Members

derek.takeno2023 — Fri, 10 Sep 2021 19:53:56 GMT

Hi,

I am unable to add new members to the frame. I made a sketch, generated a frame, then edited the sketch. New lines are shown in the image below. However, when I go to edit it, I cannot select those new lines. Is this not possible? Any help will be appreciated.

Thank you

Re: Adding Frame Generator Members

SharkDesign — Fri, 10 Sep 2021 20:14:36 GMT

It's difficult to see from your image.

Try double clicking the frame first to edit in place and then add them.

Also is your filter within the frame member dialogue set to select lines or point to point?

Re: Adding Frame Generator Members

gcoombridge — Fri, 10 Sep 2021 20:28:33 GMT

If the sketch you have highlighted is the one you're trying to change, leave that one alone. It is automatically created as frame generator adds members. Whether you created the frame from a parts sketch or an assembly sketch edit that instead...