topic Re: Simple loft issue in Inventor Forum

Simple loft issue

Cameron.WelchX97VR — Fri, 10 Jun 2022 01:12:19 GMT

Good evening all,

I am trying to loft a simple shape to cut a section of my part out. I have checked to make sure my loops are closed and tried using both the centerline and guide rail method. However, the issue arises in the fact that I can not select both sketches at the same time. The two sketches are sketch 13 and 14. I also downloaded a model from another loft issue thread and when I deleted the working loft that they created, I could not recreate it due to it not allowing me to pick more than one sketch. Any and all help will be greatly appreciated.

Thank you,

Cameron

Re: Simple loft issue

arron.craig — Fri, 10 Jun 2022 01:25:13 GMT

Does this workflow not work for you?. You need to "click to add sketch" after selecting the first one. And ideally should set your construction sketches as such.

Re: Simple loft issue

Cameron.WelchX97VR — Fri, 10 Jun 2022 01:29:13 GMT

Yup, that did it. I was not clicking add sketch after selecting the first one.

Thank you very much.