topic Re: unable to select the last member for Irregular angle in Inventor Forum

unable to select the last member for Irregular angle

eladm — Sun, 10 May 2026 09:45:52 GMT

in Circular pattern when want to use irregular angle I can't select the last member

anybody else have also this problem ?

at linear pattern there is not have this problem

regrads

Re: unable to select the last member for Irregular angle

kacper.suchomski — Sun, 10 May 2026 09:56:08 GMT

That's very logical. You've already defined its location.

Re: unable to select the last member for Irregular angle

eladm — Sun, 10 May 2026 09:59:23 GMT

No - it is just a picture

you cannot select the last member

Re: unable to select the last member for Irregular angle

kacper.suchomski — Sun, 10 May 2026 10:05:34 GMT

Yes, because its position is determined by the value you entered. If you entered 360 degrees for the full distribution and 6 pieces, the last piece will be the quotient of these values.
This is pure and hard logic.

You have two options:

Change the full distribution value (red)
Change the Mode from full distribution to individual distribution (yellow)

Re: unable to select the last member for Irregular angle

eladm — Sun, 10 May 2026 10:11:29 GMT

for change the angle different than 360 - still cannot select the last member

2- don't want to use this method , for some reasons

Re: unable to select the last member for Irregular angle

kacper.suchomski — Sun, 10 May 2026 10:16:50 GMT

@eladm wrote:

for change the angle different than 360 - still cannot select the last member

2- don't want to use this method , for some reasons

Because it's determined by the value you entered. Please don't fight the logic.

You can parameterize this value.

Re: unable to select the last member for Irregular angle

jnowel — Sun, 10 May 2026 16:01:55 GMT

@eladm maybe below illustration will help you understand what @kacper.suchomski is saying
The angle in red will be driven dimension based on your existing inputs.

The total angle (226 deg) is a driving dimension.

You cannot specify angle A as another driving dimension like you did in the other angles.
But you can specify it like shown below (where the d12 to d15 are just the parameters created when the circular pattern was created).