https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524272#M384659 <P>Still new to Inventor 2015. I make this hand wheel. Is it modelled correctly or can i make improvements to the technique used?</P><P>&nbsp;</P><P>Regards,</P><P>&nbsp;</P><P>Peter</P> Sun, 01 Mar 2015 11:58:57 GMT Anonymous 2015-03-01T11:58:57Z https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524272#M384659 <P>Still new to Inventor 2015. I make this hand wheel. Is it modelled correctly or can i make improvements to the technique used?</P><P>&nbsp;</P><P>Regards,</P><P>&nbsp;</P><P>Peter</P> Sun, 01 Mar 2015 11:58:57 GMT https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524272#M384659 Anonymous 2015-03-01T11:58:57Z https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524274#M384660 <P>A work of art, a thing of beauty!</P> <P>You probably could have done both Sketch1 and 2 on the same plane (perhaps in the same sketch) and eliminated a couple of dimensions.</P> Sun, 01 Mar 2015 12:07:50 GMT https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524274#M384660 JDMather 2015-03-01T12:07:50Z https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524277#M384661 <P>Thanks for the feedback</P> Sun, 01 Mar 2015 12:21:07 GMT https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524277#M384661 Anonymous 2015-03-01T12:21:07Z https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524278#M384662 <P>Check this example - I changed you spoke very very slightly - resulting in 4 fewer dimensions required.</P> <P>&nbsp;</P> <P>After a bit of reflection - I realized Sketch1 could have been simplified with at 3-Point Rectangle.</P> Sun, 01 Mar 2015 12:41:29 GMT https://forums.autodesk.com/t5/inventor-forum/part/m-p/5524278#M384662 JDMather 2015-03-01T12:41:29Z