topic Re: origin placement problem in Inventor Forum

origin placement problem

Anonymous — Sun, 31 Jan 2016 14:40:33 GMT

Hello guys,

It does not show the values properly because of the wrong origin placement. How can i change the angle of the origin?

Best regards,

mdavis22569 — Sun, 31 Jan 2016 16:48:46 GMT

share the part and IDW...

it'll make it easier

Anonymous — Sun, 31 Jan 2016 17:00:51 GMT

Thank you in advance

mdavis22569 — Sun, 31 Jan 2016 17:40:27 GMT

So here's the issue ...

The origin for your hole table does it vertical and horizontal

you've projected it at an angle in a sense...as you can see in this picture

So if you rotate the view, it would be correct.

This view above rotate is also how it would be set up to be drill most if not all of the time.