topic Re: wire form in Inventor Forum

wire form

Anonymous — Fri, 22 Apr 2016 21:15:05 GMT

Hello everybody,

I'm trying to form wire as the shape in the attached file but no success even I've tried spline tool.

Is there any solution?

Regards,

atajabbas

inventor 2016

Re: wire form

JDMather — Fri, 22 Apr 2016 22:27:01 GMT

Well, I made a mistake on my first attempt, but the attached should give you an idea.

Re: wire form

Anonymous — Sat, 23 Apr 2016 19:53:49 GMT

Well Mr. Mather it is a very nice solution and it gives me a good skills.
Thankyou
Regards,
atajabbas
Inventor 2016 user

Re: wire form

Anonymous — Wed, 04 May 2016 18:48:26 GMT

Hi JD Mather,

Well, I have tried to follow what you did in the 3D sketch mod, but I couldn't> Also Itried to follow your step to form the spring end in the attached ipt to apply some fillet and eliminate the sharp corner. Would you please tell me how?

Regards,

atajabbas

Re: wire form

JDMather — Wed, 04 May 2016 19:34:53 GMT

Maybe something like this is what you are after. (see attached file)

Re: wire form

JDMather — Wed, 04 May 2016 20:39:50 GMT

I might have to come up with a better solution - that one is not fully parametric.

Re: wire form

Anonymous — Fri, 06 May 2016 21:14:23 GMT

Thank you so much for your reply.

May be I seem boring, but, with my apologize, I followed your steps to do it but no success. Indeed I do not know how to use the "Intersection" tool, where , how, why and when?

The attached file is my attempt to follow your steps. Would you please tell me where is my mistake. This will make me understand how to use the tool

Thank you a lot,

atajabbas