iLogic and Scaling View Size Automatically

chayman — Fri, 07 Apr 2017 15:35:49 GMT

Hi there,

I was trying to find any information regarding my questions within the forum but I did not have any luck.

My problem: I have a master assembly that is associated with a master drawing. The master assembly can double/tripple/or even shrink by as much in size. Each time I have to go back into the drawing, scale it so it looks presentable on the dwg, and then fix around all the dimensions accordingly - this is probably the most annoying because the dimensions are always off center and out of line everywhere.

Is there a link someone can show me or a past forum page that can push me in the right direction? Any help is appreciated!

Craig H

Re: iLogic and Scaling View Size Automatically

Curtis_W — Fri, 07 Apr 2017 16:28:47 GMT

Hi chayman,

Try this link:

https://forums.autodesk.com/t5/inventor-forum/automatic-scale-and-view-position/m-p/5784680

Or this one:

https://forums.autodesk.com/t5/inventor-forum/change-drawing-scale-with-ilogic-upon-parameter-change/m-p/5414193#M528779

Also just as a tip, you can search and ask programming questions of this type on the Inventor Customization forum too:
http://forums.autodesk.com/t5/Autodesk-Inventor-Customization/bd-p/120

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

topic Re: iLogic and Scaling View Size Automatically in Inventor Forum

iLogic and Scaling View Size Automatically

Re: iLogic and Scaling View Size Automatically