topic Betreff: Could someone make me a small pulley? in Inventor Forum

Could someone make me a small pulley?

Anonymous — Fri, 28 Apr 2017 08:22:18 GMT

could someone please create a small pulley for a motor on autodesk? 30mm diameter 5mm thick disk with a radius around it 2mm deep. 1.95mm diameter hole in the center. the reason i need this is because i am making a robot in school but i can't make the piece in autodesk, i keep getting errors and it keeps deleting itself when i try to add the center hole. just attach the file to a comment if you can.

Thank you.

Betreff: Could someone make me a small pulley?

S_May — Fri, 28 Apr 2017 08:41:14 GMT

So OK?

MFG

Sascha May

Betreff: Could someone make me a small pulley?

Anonymous — Fri, 28 Apr 2017 08:49:14 GMT

whoops, sorry i didnt specify, inverted radius.

Betreff: Could someone make me a small pulley?

S_May — Fri, 28 Apr 2017 09:10:02 GMT

Is that your wish

(Radius outside is no belt )

Betreff: Could someone make me a small pulley?

Anonymous — Fri, 28 Apr 2017 09:39:48 GMT

actually no that wasn't what i was after sorry. the shape should be like a spool for cotton but very flat, so side view would be

)===( the sides caved in and the inside filled with a hole where you put it the first time in the centre

Re: Could someone make me a small pulley?

JDMather — Fri, 28 Apr 2017 12:29:24 GMT

@Anonymous wrote:

... i keep getting errors and it keeps deleting itself when i try to add the center hole. ....

Can you attach your file here (even with the "deleted itself with hole).

Someone will figure out the issue and you will actually learn something in the process.