Multiple Fillets

Anonymous — Fri, 23 Jun 2017 19:40:47 GMT

Hi everyone,

I'm working on a copper heatsink for a circuit board, and there are a bunch of square and rectangular cutouts on it at various depths for the board components. I need these cutouts to all have a 1.2mm radius on the four edges. Is there any way to apply a radius to all of these edges at once? If I select all fillets or all rounds, then it puts fillets around the bottom of the cutout as well.

I was wondering if you could limit the direction of edges that are selected, i.e all edges in the x direction get the fillets, whereas edges not aligned with the x direction do not.

I've attached a picture of it, this is just the start as there are more cutouts to go on it.

Thanks!

Kris

Re: Multiple Fillets

johnsonshiue — Fri, 23 Jun 2017 21:28:52 GMT

Hi! You may want to try Rule Fillet. Go to Ribbon panel and right-click -> check Plastic Part panel. You will find Rule Fillet command. If you cannot figure out, please share the file here or send it directly to me (johnson.shiue@autodesk.com).

Many thanks!

topic Multiple Fillets in Inventor Forum

Multiple Fillets

Re: Multiple Fillets