topic Re: Creating Multiple Emboss Lengths From One Sketch in Inventor Forum

Creating Multiple Emboss Lengths From One Sketch

Anonymous — Thu, 27 Jul 2017 06:35:21 GMT

Hello,

I am trying to make a part in which there is a embossed Xbox logo. I am trying to make the center X embossed a short amount and the rest surrounding circle a longer amount. Is there anyway to do this from one sketch?

Re: Creating Multiple Emboss Lengths From One Sketch

salariua — Thu, 27 Jul 2017 07:18:14 GMT

you can revolve a surface and then extrude, up to that surface. post your attempt if you can't figure it out.

Re: Creating Multiple Emboss Lengths From One Sketch

mcgyvr — Thu, 27 Jul 2017 12:52:07 GMT

In general yes..

Do your sketch..

extrude once on one profile

the right click on the sketch in the model browser and pick "share sketch"

then extrude the other profile again..

Re: Creating Multiple Emboss Lengths From One Sketch

Anonymous — Fri, 28 Jul 2017 01:57:17 GMT

Thank you for the help! The solution worked fine.