topic Angle Constrain in Inventor Forum

Angle Constrain

vandiverdiantrisdianto — Sat, 06 Apr 2024 06:31:34 GMT

Hello everyone! I want to do like this with constrain, can I?(on the picture)

1. I want the cylinder axle inside the square hollow

2. I want the wheel attach to the frame edge

Re: Angle Constrain

JDMather — Sat, 06 Apr 2024 09:32:46 GMT

Yes.

Re: Angle Constrain

Sergio.D.Suárez — Sat, 06 Apr 2024 12:42:10 GMT

Hi, I hope you are doing good.

1 - The square hole should have a work axis in its center, then you would create a cylinder axis constraint with a square axis

2 - The wheel must have an axis from which to rotate. The same previous method applies, you must have two working axes available in each piece

Re: Angle Constrain

James_Willo — Mon, 08 Apr 2024 05:16:47 GMT

If your box section was drawn correctly around the origin, you can even use the Inventor origin axis of the box section to mate with your axle. The axis doesn't have to be visible to mate to it, so don't fall into the trap of making everything visible, just click it in the browser.