topic Re: Inventor Drawing Internal Thread Marking While Placing Views in Inventor Forum

Inventor Drawing Internal Thread Marking While Placing Views

Anonymous — Tue, 01 May 2018 17:31:46 GMT

Hello everyone, I'm having a bit of a problem with thread marking. Basically, whenever I create an inner thread, the thread shows as outer while placing views. I'm relatively new to Inventor, so I don't know if there is any other way to mark all threads inside of the circle (as I'm told in the university)? Screenshot's attached.

kelly.young has edited your subject line for clarity: Thread marking

Re: Inventor Drawing Internal Thread Marking While Placing Views

Mark.Lancaster — Tue, 01 May 2018 17:32:04 GMT

In drafting standards. An internal or female threaded hole will show the dashed or circle to represent the thread portion you can't see. That's why you see it like that in the view. An external or male thread is the opposite way. Your school studies should be teaching your some drafting standards and not just buttons in CAD.

Re: Inventor Drawing Internal Thread Marking While Placing Views

Mark.Lancaster — Tue, 01 May 2018 17:32:18 GMT

@Anonymous

See figure 5 here: http://courses.me.metu.edu.tr/courses/me117/Lectures/screw_threads.htm to understand how simplified thread representation is created in drawing (views).

Re: Inventor Drawing Internal Thread Marking While Placing Views

TheCADWhisperer — Tue, 01 May 2018 17:32:33 GMT

@Anonymouswrote:

.... (as I'm told in the university)?

Can you ask your instructor to join this discussion?

Re: Inventor Drawing Internal Thread Marking While Placing Views

kelly.young — Tue, 01 May 2018 17:32:45 GMT

Hello @Anonymous I see that you are visiting as a new member to the Inventor Forum.
Welcome to the Autodesk Community!

Are you trying to change the scale of the dashed line to fit better?

You can also change the Layers > Layer Styles > Line Type to fit as well.

I don't know if you have any experience with creating threads, but the center hole is created first, then a secondary operation comes in and cuts the thread into the hole.

You can notate the thread from Annotate > Feature Notes > Hole and Thread.

Please select the Accept as Solution button if a post solves your issue or answers your question.