topic Re: Bolted Connection Costume Content Center parts Table not showing all columns in Inventor Forum

Bolted Connection Custom Content Center parts Table not showing all columns

Anonymous — Tue, 05 Apr 2022 17:12:21 GMT

When I create a bolted connection using the content center parts I have created and go in select the "..." to choose which nut of that size I want, all I see is the below table.

But when I go to place from content center the same nut, all my Key Columns show up in the table. (Shown below)

My question is how do you get the bolted connection table to look like the "place from Content Center" table?

Thank you!

Re: Bolted Connection Costume Content Center parts Table not showing all columns

blair — Mon, 19 Nov 2018 19:47:39 GMT

You can't. The Bolted Connection function was added long after the CC was added. Perhaps in future releases, they might have enough resources to make both look the same.

Re: Bolted Connection Costume Content Center parts Table not showing all columns

Anonymous — Mon, 19 Nov 2018 19:55:08 GMT

Thanks!

hope they make that update because the bolted connection is nice, but without the table, it's hard to see the correct finish without looking at the ERP system first.

Re: Bolted Connection Costume Content Center parts Table not showing all columns

fce — Tue, 05 Apr 2022 10:46:48 GMT

Hello,

I got the same problem. Any updates?

Best Regards,
Francisco

Re: Bolted Connection Custom Content Center parts Table not showing all columns

Chad_WieheSSZKH — Fri, 12 Dec 2025 13:39:14 GMT

I am encountering this same issue in 2024 version. Has any resolution been found? We stock fasteners in multiple finishes and would really rather not create multiple families just based on finish or even thickness in the case of washers.