topic Re: Mass with model state in Inventor Forum

Mass with model state

ZFerrarini — Mon, 10 Jun 2024 15:50:36 GMT

I created a part with few model states in Inventor 2023.

I would like to create a table with the mass of every model state.

Is it possible?

thank you in advance.

Re: Mass with model state

blandb — Mon, 10 Jun 2024 16:16:52 GMT

This might help lead you:

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/How-add-mass-of-each-model-state-to-display-them-in-the-drawing-table-in-Invenotr.html

Re: Mass with model state

ZFerrarini — Mon, 10 Jun 2024 17:31:30 GMT

I am not sure what iLogic code I need to write.

Re: Mass with model state

blandb — Mon, 10 Jun 2024 18:16:59 GMT

at the bottom, if you click on the "ilogic mass update properties" link in the ilogic section, it brings up this form where a user has written some code. I have attached that forum post below.

https://forums.autodesk.com/t5/inventor-programming-ilogic/ilogic-mass-properties-update/td-p/3571514

Re: Mass with model state

ZFerrarini — Mon, 10 Jun 2024 18:37:39 GMT

Thank you.