2020.2 Change to construction/centerline - intended?

thenottakenname — Thu, 28 Nov 2019 18:14:00 GMT

Hello all,

I noticed since updating to 2020.2 that there was a behaviour change on the sketch level. Normally if I had to draw a construction or center line, I would click "Line", then click the box under "Format" for either construction or center. I would draw the line, hit escape, and the setting for contruction/center would unselect itself so I could draw normally again after hitting the spacebar. If either was selected before clicking "Line", then they would stay enabled after hitting escape.

Now, on this new patch, I have to manually deselect construction/centerline, regardless of whether I enabled them before or after engaging the "Line" command. Was this intended?

Thanks in advance!

Re: 2020.2 Change to construction/centerline - intended?

Xun.Zhang — Fri, 29 Nov 2019 01:53:53 GMT

Hello Aaron,

The command sequence you've mentioned like Line -> toggle center line -> ESC will not reset toggle of center line in my end for both 2019, 2020.

Could you help provide a video to us for the workflow?

Thanks

topic Re: 2020.2 Change to construction/centerline - intended? in Inventor Forum

2020.2 Change to construction/centerline - intended?

Re: 2020.2 Change to construction/centerline - intended?