https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12973264#M14205 <P>Hi Jocean,</P> <P>&nbsp;</P> <P>It is doable. Exporting a DXF file from the Flat Pattern allows you to designate what sheet metal geometry should be on what layer.</P> <P>Here is a short video showing the workflow.</P> <P>&nbsp;</P> <P><A href="https://www.youtube.com/watch?v=E5pPrrZ95uA" target="_blank">https://www.youtube.com/watch?v=E5pPrrZ95uA</A></P> <P>&nbsp;</P> <P>Many thanks!</P> <P>&nbsp;</P> Wed, 21 Aug 2024 20:35:48 GMT johnsonshiue 2024-08-21T20:35:48Z https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12972618#M14204 <P>I'm trying to export a DXF with a bend line on the second layer so the laser can just etch layer 2</P> Wed, 21 Aug 2024 15:18:21 GMT https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12972618#M14204 jocean_vieiraZ9YQS 2024-08-21T15:18:21Z https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12973264#M14205 <P>Hi Jocean,</P> <P>&nbsp;</P> <P>It is doable. Exporting a DXF file from the Flat Pattern allows you to designate what sheet metal geometry should be on what layer.</P> <P>Here is a short video showing the workflow.</P> <P>&nbsp;</P> <P><A href="https://www.youtube.com/watch?v=E5pPrrZ95uA" target="_blank">https://www.youtube.com/watch?v=E5pPrrZ95uA</A></P> <P>&nbsp;</P> <P>Many thanks!</P> <P>&nbsp;</P> Wed, 21 Aug 2024 20:35:48 GMT https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12973264#M14205 johnsonshiue 2024-08-21T20:35:48Z https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12974611#M14206 Thanks, all that time I was "exporting face as". Thanks that helps a lot Thu, 22 Aug 2024 11:29:11 GMT https://forums.autodesk.com/t5/inventor-forum/export-of-dxf-export-bend-line-on-layer-2/m-p/12974611#M14206 jocean_vieiraZ9YQS 2024-08-22T11:29:11Z