topic Re: Trying to export point trace from dynamic simulation in Inventor Forum

Trying to export point trace from dynamic simulation

martin.brezova — Sat, 20 Feb 2021 12:30:58 GMT

Hello guys,

I need to make a render of this attached 4 bar linkage, but would like the render to include traces of points from dynamic simulation. I know there is a option in the output grapher to export the trace to sketch, but in my case it looks like its doing nothing. I have never exported point trace before so I don´t where it should appear. I suspected it to export the sketch back to the assembly.

I would be grateful for every advise

Thanks

Re: Trying to export point trace from dynamic simulation

JDMather — Sat, 20 Feb 2021 12:51:13 GMT

When you click Export to Sketch > what does the prompt in lower left of screen say?

(Unfortunately I doubt this is going to give you what you want - but let me give it an experiment.)

Re: Trying to export point trace from dynamic simulation

JDMather — Sat, 20 Feb 2021 13:27:50 GMT

@JDMather wrote:

When you click Export to Sketch > what does the prompt in lower left of screen say?

~~(Unfortunately I doubt this is going to give you what you want - but let me give it an experiment.)~~

@martin.brezova See Attached files.

Re: Trying to export point trace from dynamic simulation

JDMather — Sat, 20 Feb 2021 13:35:00 GMT

@JDMather wrote:

When you click Export to Sketch > what does the prompt in lower left of screen say?

~~(Unfortunately I doubt this is going to give you what you want - but let me give it an experiment.)~~

Re: Trying to export point trace from dynamic simulation

martin.brezova — Sun, 21 Feb 2021 14:08:44 GMT

Thanks, I didn´t see the prompt. Now I am able to fully execute the command. Thanks for your comments.