topic Re: iLogic and Sketches in Inventor Forum

iLogic and Sketches

Anonymous — Tue, 11 May 2021 21:30:24 GMT

Hello ,

How can I array (Pattern) a sketch (of a part that placed into an assembly) from that assembly by iLogic?

Thank you

Re: iLogic and Sketches

blandb — Tue, 11 May 2021 22:19:03 GMT

I'm not certain I fully understand what you are trying do to.

Re: iLogic and Sketches

Anonymous — Tue, 11 May 2021 22:29:03 GMT

I have a part file contains of two sketches

The part file placed in an assembly file in order to use the sketches as
skeleton sketch for frame generator

I want to control the sketch dimensions and sketch pattern from the
assembly file by iLogic

I wanna know how to create a pattern from one of the sketches in the
assembly by iLogic

Re: iLogic and Sketches

johnsonshiue — Wed, 12 May 2021 00:04:12 GMT

Hi! I don't think such workflow exists. Sketch geometry can be patterned. But, the sketch itself cannot be patterned. The closet thing is patterning part (containing the sketch) in assembly. Is it what you are looking for?

Many thanks!

Re: iLogic and Sketches

Anonymous — Wed, 12 May 2021 05:28:51 GMT

Hello,

Thanks for the response. This is what I did so far

I have an assembly file with a placed part. The placed part is a skeleton model with just a sketch.

in the assembly file, I have a rule with the following code

When I run the rule, it is working, and the result is correct, but I faced the below error message.

Re: iLogic and Sketches

blandb — Wed, 12 May 2021 12:50:36 GMT

Is there a reason you don't make the frame weldment, then place that into an upper level and pattern it from there?