topic No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode in Inventor Forum

No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

Gurpreet.Badwall — Thu, 27 May 2021 19:39:28 GMT

Hi Inventor Experts,

I am not sure if this is the case with Inventor. When I use Half Section View command under View Tab in Part Mode, Inventor is not showing the Section Hatch Lines. Please have a look on the attached Inventor Part File and Screenshots. It does show the Half Section View but without the Hatch Lines.

NOTE: Just letting you know , I am not talking about the Half Section View in Drawing Mode.

Inventor Version Used: Inventor Professional 2021.3.1

Regards

Gurpreet

Re: No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

bradeneuropeArthur — Thu, 27 May 2021 19:44:00 GMT

That is normal behavior!

Re: No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

Gurpreet.Badwall — Thu, 27 May 2021 19:50:49 GMT

@bradeneuropeArthur Thanks a lot Dear for your quick response.

I am also Fusion 360 user and its showing the Hatch Line in Part Mode when I use the Half Section View command.

Re: No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

bradeneuropeArthur — Thu, 27 May 2021 19:53:02 GMT

Would be a good thing for the Idea Station, I would vote it!

Re: No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

johnsonshiue — Thu, 27 May 2021 19:54:38 GMT

Hi! Do you want to see the 2D hatch pattern in 3D model? I don't think it is supported. The closest thing I can think of is to create shaded section view in the drawing.

Many thanks!

Re: No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

Gurpreet.Badwall — Thu, 27 May 2021 19:57:54 GMT

@johnsonshiue Thanks a lot for your reply. Just letting you know I am also a Fusion 360 user and it does offer the Hatch Lines in Part Mode when I use the Half section view.

Note: I already have hatch lines when I create the Section view in Drawing mode in Inventor.