topic CLOVERLEAF IN INFRAWORKS, INTERCHANGE PROBLEM in InfraWorks Forum

CLOVERLEAF IN INFRAWORKS, INTERCHANGE PROBLEM

Beka_Tchigladze — Fri, 16 Aug 2019 12:30:45 GMT

HELLO

So I want to make some design of cloverleaf made an assembly of road and sweep it on one alignment now I want to add ramps but it does not work properly I want to interchange to connect with one lane and not conflict to others. what should I do to solve the problem. and what should I foresee when making interchanges of roads in Infraworks?

here is a screen shot

Re: CLOVERLEAF IN INFRAWORKS, INTERCHANGE PROBLEM

roskirko — Sun, 18 Aug 2019 02:04:58 GMT

Perhaps trying several independent componenet "roads" would help. Use one set of components for one of the directions; another for the other direction and perhaps a third for the median.

Re: CLOVERLEAF IN INFRAWORKS, INTERCHANGE PROBLEM

Beka_Tchigladze — Sun, 18 Aug 2019 04:13:53 GMT

@roskirko

thank for your replay.

yes maybe but donot forget that I have 3 road in this case if I split directions and I need same vertical profiles how to match vertical profiles if I split?

Re: CLOVERLEAF IN INFRAWORKS, INTERCHANGE PROBLEM

Anonymous — Mon, 19 Aug 2019 16:25:15 GMT

Hi @Beka_Tchigladze ,

Actually, you should have four roads: two intersecting and two ramps. For every ramp, you should play with lane components as you can see on the screen shots. Sleep road lane should have right direction.

Regards,

Goran

Re: CLOVERLEAF IN INFRAWORKS, INTERCHANGE PROBLEM

Beka_Tchigladze — Mon, 19 Aug 2019 18:31:28 GMT

it does not work with same way in my case