https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8295719#M6644 <P>Which post are you using? I get arc moves both with 2D contour with ramp, and Bore, using Haas post. Normally I would use bore for feature like this.</P> Thu, 27 Sep 2018 02:17:09 GMT Anonymous 2018-09-27T02:17:09Z https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8295667#M6643 <P>Trying to interpolate inside a .32" diameter cavity that is .1" deep with a .25" endmill.&nbsp; No matter how I set the leads in the linking tab of 2D Contour I can't get a toolpath.&nbsp; I tried Circular but the roughing amount seemed odd and not easily controlled (was going to rough then finish).&nbsp; Bore seems to be some sort of thread milling?&nbsp; That posts with just lines of code - I would like to see I and J.</P><P><BR />Thanks!</P> Thu, 27 Sep 2018 01:13:20 GMT https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8295667#M6643 Anonymous 2018-09-27T01:13:20Z https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8295719#M6644 <P>Which post are you using? I get arc moves both with 2D contour with ramp, and Bore, using Haas post. Normally I would use bore for feature like this.</P> Thu, 27 Sep 2018 02:17:09 GMT https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8295719#M6644 Anonymous 2018-09-27T02:17:09Z https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8296170#M6645 The standard haas killing post<BR /> Thu, 27 Sep 2018 08:37:00 GMT https://forums.autodesk.com/t5/hsm-forum/best-feature-to-use-for-id-boring/m-p/8296170#M6645 Anonymous 2018-09-27T08:37:00Z