topic Re: Radial Mill in a Turn/Mill center in HSM Forum

Radial Mill in a Turn/Mill center

Anonymous — Fri, 24 May 2019 06:10:22 GMT

Hey

I have a part that I have to turn in a Turn / Mill center (4th axle, X, Y, Z, C) where I have to make a chamfer on the end of the part, with a asymmetrical, for I can do it I need a LiveTool that is Radial. I want the Tool to run in the X and C axle

at the same time, but I have not succeeded in finding a way in which I can get HSM to do it.

in advance thank you for your answer

Re: Radial Mill in a Turn/Mill center

Laurens-3DTechDraw — Wed, 29 May 2019 05:56:47 GMT

Hi Man,

The attached file should work.

Yet I personally would try a back chamfer tool. Probably is faster and creates a better surface finish.

Re: Radial Mill in a Turn/Mill center

Anonymous — Wed, 29 May 2019 06:21:12 GMT

Thank you.

It works like a charm, good idea with back chamfer but I don't have one available right now

maybe I should get one 😉