topic 3D Adaptive in build HSMWorks 2016 R4.41148 in HSM Support Forum

3D Adaptive in build HSMWorks 2016 R4.41148

lenny_1962 — Thu, 08 Sep 2016 16:46:36 GMT

I have a big arc that move from one position to another, see pic, I have tried everything to get it to pull out and rapid to the next position with no luck.

anyone else finding this?

Re: 3D Adaptive in build HSMWorks 2016 R4.41148

Laurens-3DTechDraw — Thu, 08 Sep 2016 17:12:17 GMT

Seen this in the past.

Have you simulated? I could just run through the part I can tel you from experience.

Pretty sure the developement guys would love to see the part.

Re: 3D Adaptive in build HSMWorks 2016 R4.41148

Rob_Lockwood — Thu, 08 Sep 2016 19:17:15 GMT

yep, have seen in the past too. Usually wind up rolling to an older release and it seems to get fixed by the next one.

Re: 3D Adaptive in build HSMWorks 2016 R4.41148

lenny_1962 — Thu, 08 Sep 2016 22:54:14 GMT

@Rob_Lockwood wrote:

yep, have seen in the past too. Usually wind up rolling to an older release and it seems to get fixed by the next one.

@Rob_Lockwood

I rolled back and still got the same thing, tried changing the step of the step reduction to no avail.

so I then made a sketch like .25 larger all the way around the stock, bam, worked the first time, who the heck know why.?

now who gets the solution?

Re: 3D Adaptive in build HSMWorks 2016 R4.41148

Steinwerks — Fri, 09 Sep 2016 01:40:12 GMT

Did you send feedback? Seems a good example of when something rarely encountered goes awry.

Re: 3D Adaptive in build HSMWorks 2016 R4.41148

lenny_1962 — Fri, 09 Sep 2016 17:29:31 GMT

@Steinwerks not allowed to send it, sorry