topic Re: Milling not constraint to model in HSM Support Forum

Milling not constraint to model

Jos_Heruvent — Mon, 23 Jan 2023 15:16:35 GMT

Hallo

I created a simple model with a simple cutout. Now I am placing a 2D Adatpive milling for the cutout. The model is 400 mm long. Now I change the length to 300 mm. However the 2D Adaptive milling does not go with it. If I reactivate the 2D Adaptive milling it goes to its new position. Is there a possibility that if you change the model the milling automatically updates with it? Imagine if you have multiple tooling in your model that you have to reopen them all one by one after a change in your model.
We work with parametric models to which all cam tooling is added and which we copy from the Vault with copy design. That new model is adjusted in length and depth. Assuming that the tooling goes automatically with the model adjustment.

Re: Milling not constraint to model

FTKnur — Tue, 24 Jan 2023 11:20:51 GMT

Why dou you open the Job and klick ok?

Alle operations will be recalculate if you right-click on the Setup and calculate it again ... or press CTRL+G on the Setup.

Change your Model with the parameters and then only recalculate the complete Setup or the whole CAM tab.

Re: Milling not constraint to model

Jos_Heruvent — Tue, 24 Jan 2023 12:29:33 GMT

Thanks, @FTKnur

Ok, its Generate Toolpath(All).

And yes, if you have more setups then you select the top row in your cam browser.